Evolution of the Arduino Dalek

The DIY Arduino Shield Kit arrived from Amazon, and has been soldered up.

emptyshieldAnd it looks really boring, without the other parts stuck on it.

The parts in question are four 5v DPDT relays (Maplin part no N05AW – which seem to be out of stock a lot of the time, but are better that the alternative BT Type 47s, as the coil isn’t fussy about the polarity of the voltage), four 1N4004S diodes (part no QL78H), and a mess of wires. Rather than try to describe the layout, I’ve drawn a really bad diagram.

Circuit-ComponentsThis is the view from the component side. The yellow boxes show the relay placements, the four vertical block are the connections to the arduino. The Cyan areas are connections on the other side of the board, either whopping great solder blobs or lines joining the pads drawn with a pcb pen. The other technicolour lines are various wires.

Although that diagram gives the impression that I’ve used a double sided board, I haven’t. In retrospect that would have made things a lot easier.

Another collosal lack of planning (ie putting the Arduino header blocks too close to the top of the board) means that the Massively Ugly Blob Of Solder at the top sits directly over the ICSP header on the <a href="http://arduino best ed pills non prescription.cc/en/Main/arduinoBoardDuemilanove”>Arduino Duemilanove that I’m using, requiring a bit of electrical tape to stop it shorting.

Here is what it looks like now, shitty soldering included for free:

2012-02-24-16.47.06 2012-02-24-16.47.19

Maybe you’ve spotted some things that aren’t on the diagram. Such as the 2 pin header, the two 3 pin headers and and 4 pin header. Well, the 2 pin is for the motor power input, and the 4 pin one is for the motor driver outputs. They were an afterthought, as were the two 3 pin headers which are for the distance sensors input, and are currently not connected. That bit comes next.

Leave a Reply